In this case just press the Ground Balance button once to return to the current sensitivity ( CS). However, if you use the automatic notch system, it is possible that the sensitivity will not be lowered. When the Custom discrimination model (notch) is selected in the metal detector, the sensitivity automatically drops to 5. Custom Discrimination Setting Update ("C") Instead, you can unmute by holding down the Frequency button.Įven if muted, the Nokta Legend metal detector will automatically return to custom discrimination mode (notch), terrain balancing, and settings menus. On the main screen, holding down the Frequency button will mute the metal detector, and the letters "AO" (Audio Off) will appear on the right side of the display. The letters AG will appear on the right side of the screen, so you can adjust the AG using the + and – buttons between 1-6, the default value is set to 3.Īudio Gain does NOT increase the depth but allows the metal detector to hear the weakest and deepest targets with a much stronger volume. In PARK, FIELD and BEACH modes, after selecting the volume, press the Pinpoint button. ![]() The Audio Gain setting will amplify the volume of the response of weak targets. This setting can be made, on the Legend Nokta Makro, by setting the number of tones and is shown with a P. In Pitch audio mode, when the coil approaches the target, the audio frequency will change in proportion to the signal strength. It reduces the effect of moisture in soils that can cause false signals and weakens the response of targets that generate ID 10-11 such as carbon coke and foil. NB: The "st" setting in beach mode is different from this new ST setting! The new multifrequency (M3) with PARK and FIELD mode When the IF is set to any value below 8, the "st" setting can be activated by pressing the right or left button and can be adjusted using the + and - buttons. When the IF is set to 8, the "st" setting will be inactive in PARK, FIELD, and GOLD FIELD modes. The stability setting (st) is the "fine" tuning for the IF setting. The iron filter (IF) setting varies from 1 to 8 where the default value is 8 (as in Legend 1.07).Ī lower IF setting will increase the likelihood that ferrous targets will be classified as non-ferrous targets and vice versa. To activate the Iron Filter (IF) setting you have to set the metal detector in the multifrequency function, and after selecting the Recovery Speed setting hold down the Pinpoint button until the "IF" symbol appears on the right side of the display. In recent days, Nokta Makro has made available the new update of its Legend metal detector: firmware 1.09.īelow are all the adjustments and news introduced in the new Legend Nokta Makro update:: New Iron Filter and Stability Settings
0 Comments
Leave a Reply. |